Leatherman MUT review

I purchased my MUT in January, and so far, I like it a lot, with only a few minor complaints.

The MUT, Military Utility Tool, was built for use with assault rifles.  If you don’t carry a rifle on a nearly daily basis, then some of the tools will be less useful, and it might be lacking in some other features more useful for civilian use.

 

Weight

The MUT is rather heavy, 11.2 oz or 317.5 grams if you prefer metric.  Compared to the Wave at 8.5/241, or the Skeletool at 5/142, it’s a bit of a chunk.  Because so much of it is for firearms (bolt override tool, disassembly punch, cleaning rod threads, carbon scraper) I guess they figure anyone who’s carrying a 7.5 pound rifle, along with spare magazines, boots, and possibly body armor, won’t mind the extra weight so much.  Considering the rest of the junk I carry around, I have no room to complain.

Less Useful Tools

While I’ve used every tool on the MUT at least once, there are some I could do without.  The carbon scraper isn’t especially useful, I’ve only used it to open boxes and locked doors.  The one time I used the saw was to cut some PVC so it would fit in my car.  The saw’s too short to be terribly useful, I’d rather have a second knife blade.  One to keep sharp, one for the dirty jobs.

The “hammer” adds some weight, and isn’t a very good hammer.  I’ve only used it to knock boards into place before fastening them.

The bolt override tool can make a reasonable lever.  Since the end is tapered, you can slide it under rat belts (zip ties) or straps, and then cut them with the belt cutter.

I don’t usually use the pocket clip, because the MUT’s pretty large to keep in a pocket.  It does work with the tool open or closed, and I do like the ability to clip it in my pocket when I’m in the middle of a project.

The safety is pretty much unnecessary, I don’t use it.

The belt cutter is always somewhat exposed, so it could potentially snag and cut things it shouldn’t.  This hasn’t been a problem so far.

I haven’t used the cleaning rod adapters, since every time I’ve needed one, I’ve had an entire cleaning kit, complete with handle.

Things I Like

The carbide wire cutters can be replaced, so I don’t have to worry about abusing them too much.  I feel like I could cut through a fish hook without too much trouble, which can be the only way to remove one from flesh.  If they do become damaged, two Torx screws hold them in place.

I’ve only used the punch a couple times, but I made a spike to replace it.  Usually I carry both.  After a few trips where a marlinspike would have been useful, I made one.  The next week, I used it to repair a tire near Goblin Valley.  The hole was small enough the standard reamer in a plug kit wouldn’t fit, I was able to open up the puncture with the spike until the normal tools could be used.  At some point, I might make a corkscrew to go with it.

The belt cutter is easily accessible, and is nice for cutting clothing tags, zip ties, tape, and cord.

Many times I’ve needed a hex or torx driver, and been happy to have those and a driver on my belt.  With the extension, standard hex shanks can be used, so I keep a few sockets in the Jeep.  A variety of sizes of screwdriver, flat and phillips, make the impromptu tightening or loosening job easy.  It’s nice to avoid trips up and down a ladder.

 

TL;DR

The MUT is big, heavy, but also has a lot of tools.  Since time to time, I do carry around rifles, it’s a pretty good choice for me.  I’d also recommend the Wave and OHT.  Gerber also has some nice ones, at more reasonable prices.